Moisture from below can.
Timber floor cupping.
Wood is hygroscopic in nature and thereby tends to absorb moisture from its surroundings causing problems in hardwood floors.
Any wood floor can suffer from cupping.
How our 950 moisture meter works is it has a hygrometer built in to read temp humidity and calculates your the emc equilibrium moisture content of what your wood floor should be.
The general effect is easy to demonstrate by putting a small strip of paper onto a small drop of water.
If you imagine a picture of a child drawing a boat in the water then the water will give you a good idea of what a cupped floor looks like.
This makes the wood appear to be in a u shape.
Cupping can also occur in rooms with dry humidity.
Cupping dry or wet wood floors can be caused by humidity lack of humidity temp water.
The cupping is due to some type of moisture imbalance in the wood flooring itself.
See the picture at the top of this post for an example of a cupped floor.
As you can see moisture and wood don t go well together.
The simplest way to think of wood floor cupping is to imagine the edges of each plank sticking up higher than the centers.
Wet maintenance can cause cupping.
Boards will remain cupped.
As the name implies the surfaces of boards that suffer from cuppinghave a concave shape.
Cupping means that the wood that is raised on the edges of each individual floor board.
Site related causes of wood floor cupping.
Cupping in solid wood floors.
When the moisture increases the wood swells and then when it decreases the wood shrinks.
The paper will curl up away from the water.
There are a number of potential causes of site related wood floor cupping.
It is not hard to see the effect in wood flooring either.
Wet crawlspaces and basements will cup a floor as moisture moves upward.
Water vapor emissions from concrete.
Increase the relative humidity in the room with cupped floors to 20 percent to prevent cupping from the air being too dry.
Cupping is a result of the changes in moisture in the room.
This imbalance could either be moisture from the concrete environmental conditions in the space being to dry and drying out the top of the wood and or a wood floor that wasn t properly acclimated to the environment prior to installation.
Wood cupping develops a set in boards ultimately boards that have cupped due to these moisture differences develop a set and remain cupped even when the boards have dried.
The center of the board dips below the edges.
You can observe this dramatically in an interior wood floor that has been flooded then dried.
It ends up looking a little like an accordion.
Wood is hygroscopic so it gains or loses moisture in your home seasonally.
The sides of each board are higher than the middle sections.
They bow inward resembling the bowl of a spoon or the inside of a cup.
