Toilet Flange Above Floor Level

In the set rite system there s four different.

Toilet flange above floor level.

Remove your broken flange if you re replacing it and insert the new one into the waste pipe. The flange should sit on top of the finished floor if it doesn t you ll have to modify the plumbing or find another way to achieve this. The process is generally the same but the flange is secured down before the floor is finished. You can use a hammer and a chisel.

Purchase a new one if the previous flange is too low purchase one that is designed to sit on the finished floor and provide the optimum toilet flange height. This particular toilet flange was 5 8 above the floor level. Though above floor installation is considered the right way to fit a flange some swear by attaching it level with the floor. This typically allows for almost any type of wax ring to be used and still ensure a good seal.

With the toilet removed you can see the toilet flange and measure its height above the floor. Once the outer portion of the flange and the fitting has. If it s a little too low then this probably won t be an issue. This would allow you to use a sponge gasket if you wanted to.

In both cases always fastening the flange to the floor or subfloor. To get the fitting out from the inside of the pipe you ll want to make two score cuts less than an inch between each. Start by removing your toilet and breaking the outer flange portion off. Your flange should be now.

Notice in this image how the toilet waste pipe sits just inside the flange opening this is the proper way for a toilet to sit on a flange. In most cases the floor of a bathroom is tiled and in this case the tiling is done after the flange is installed. Give some thought to the height of the finished floor and you should be able to work out how high it needs to be. The optimum toilet flange height is approximately inch above the floor to achieve the best seal and overall fit.

The perfect height for the toilet flange is to be the same level as the finished floor. Next you ll want to choose the right spacer from the extender system. We in canada place our platic flanges flush with the finished surface level with the tile floor and or 1 8 higher than the finished surface.